Mitel 3300 Uživatelský manuál stáhnout pdf (Strana 146)

3300 ICP Hardware User Guide

138 Release 3.3

Connect Fiber Cable to the Peripheral Unit

The fiber optic cable connects the FIM in the 3300 Controller to the FIM in the Peripheral Unit.

To connect the fiber optic cable to the FIM in the peripheral node:

1. Review the guidelines for handling fiber optic cable.

2. Route the fiber optic cable through the cable port at the rear of the peripheral cabinet into

the cabinet. Extend the fiber cable approximately 30 cm (1 ft) beyond the front of the

cabinet.

3. Install a short piece of nylon spiral wrap over the cable at the point where the cable exits

the rear of the cabinet.

4. Close the sliding cable port door. Ensure that the door closes on the nylon spiral-wrapped

section of fiber cable.

5. Remove the plastic dust caps from the fiber optic cable and the connector ferrules on the

FIM faceplate.

6. Plug the fiber connectors into the connectors on the FIM faceplate. The fiber connectors

have a small key that must be aligned with a slot on the FIM connectors. Lock each

connector into position by pushing the metal collar forward and clipping it onto the FIM

connector.

1 2 ... 141 142 143 144 145 146 147 148 149 150 151 ... 265 266

Žádné komentáře

Mitel 3300 Uživatelský manuál Strana 146