Mitel 200 Uživatelský manuál stáhnout pdf (Strana 59)

Troubleshooting and Repair

Troubleshooting

Flowchart 2: System Is Not Booting

Is the Main Control Card

in a cycle showing an Eb

error code?

Yes

Is the Main

Control Card

in a cycle showing any

E-0/1/2/3/4/5/6/7/8/9

error codes? If E.8

see p.54.

Yes

Main Control Card (or onboard

module) failure

Reseat all Control Cabinet cards

Replace Main Control Card (and/or

appropriate modules).

Replace Control Cabinet.

Flowchart 2:

System is not booting.

Boot Error

For SX-200 LIGHT, reseat all Control

Cabinet cards.

Replace the system disks with known

good copies (use known good backups

because disk drive problems may

corrupt the booting disks).

Check disk drive cables.

Replace disk drives (check that disks are

in the correct drive).

For SX-200 EL/ML, power down, reseat

the Flash card (PCMCIA) , reseat MCC,

replace Flash Card, reseat System ID.

Any other combination

of LEDs and 7-segment

LED displays not

covered?

End

Main Control Card or Main Control

Cabinet problem

Reseat all Control Cabinet cards.

Try swapping the suspect Main Control

Card in a known working cabinet.

Try swapping a known working Main

Control Card in the suspect cabinet.

Yes

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 263 264

Komentáře k této Příručce

Žádné komentáře

Mitel 200 Uživatelský manuál Strana 59

Komentáře k této Příručce

Související produkty a manuály pro Telefony Mitel 200